Plastic material source for a small enclosure

i want create enclosure prototype. it's small project, 1" cube. want lightweight (the electronics, display , battery weigh 15g) needs have rigidity. must opaque or easy way make opaque. needs material can cut , drill , glue can fit it, allow display poke through, , buttons.

i think may harder me make electronics , software.

any ideas?

you can several layers of plexiglas or acrylic sheets. cut profiles layers form cavity components inside. can drill 4 holes on corners , fasten them screws, or bond them together. result transparent , customization many designs. not water proof. ip 41 @ best.

here general idea

and onshape design layout.

Arduino Forum > Using Arduino > Project Guidance > Plastic material source for a small enclosure

arduino