8"Touch Shield LCD Display Module w/SSD1963 not displaying anything

i copied header file available bought screen (it can found attached) run in arduino. thing changed interface format, since using 8-bit parallel , code uses 16-bit. code compiles there no display in screen. screen 800 x 480. use since stuck , don't know how trouble shoot wrong. have downloaded other codes (usually 7" same pixels) , don't output anything. makes me believe wire connection wires being used enabler, read/write, data/command, chip select , 8-bits, , connected correctly. if take @ code , me please.

2 threads same problem not way go!

as stated in other thread, use 16 bit parallel , utft library.

regards,

graham

Arduino Forum > Using Arduino > Displays > 8"Touch Shield LCD Display Module w/SSD1963 not displaying anything

arduino