DSI / MIPI Display with RPI 3 b+ or CM3 - Raspberry Pi Forums

hi --

sorry education level on interfaces not par folks here, that's why i'm writing. i'm volunteer on project charitable organization in america. want source form-factor display (8" x 4") , supplier i've been speaking has following mipi compatible display.

wondering, given dsi interface on pi 3 b, how work control display rpi?

pinout given below. looks 4 lane dsi connection. thoughts on feasibility of getting working, ideally without separate controller board?

in advance!

display specs here:

• pin no signal i/o description
  
  1 gnd p ground
  
  2 nc no connection
  3-4 led+ p led anode
  5 nc no connection
  6-7 ledk- p led cathode
  8 nc no connection
  9 gnd p ground
  10 nc no connection
  11 avdd p power analog circuit
  12 nc no connection
  13 vgh p gate on voltage
  14 nc no connection
  15 vgl p gate off voltage
  16 nc no connection
  17 gnd p ground
  18 vcom p common voltage
  19-20 gnd p ground
  21 reset p global reset pin
  22 vdd p dc-dc circuit supply voltage(3v-4.2v)
  23 stbyb p stand
  24 tp_sync o sync signal touch panel
  25 gnd p ground
  26 dop mipi data input laneo positive-end
  27 don mipi data input laneo negtive-end
  28 gndp ground
  29 d1p mipi data input lane1 positive-end
  30 d1n mipi data input lane1 negtive-end
  31 gnd p ground
  32 clkp mipi clock input positive-end
  33 clkn mipi clock input negtive-end
  34 gnd p ground
  35 d2p mipi data input lane2 positive-end
  36 d2nmipi data input lane2 negtive-end
  37 gnd p ground
  38 d3p mipi data input lane3 positive-end
  39 d3n mipi data input lane3 negtive-end
  40 gnd p ground

at present official rpf screen can used in display (dsi) port on rpi.
imo find hdmi screen or hdmi controller board screen if 1 exists.

raspberrypi