i bought new computer. has intel i5 750 processor, gigabyte p55a-ud4 motherboard , 4 gb of kingston hyperx ddr3 ram.
ram supports xmp , can run @ 1600 mhz, runs @ 1333 mhz default. tried enable xmp bios setting profile 1, computer won't pass post. "no signal" message on monitor, , next time boot bios says failed boot last time , has reverted previous settings.
know forum section more linux compatibility , has nothing ubuntu or linux, have experience xmp , know how can working? have no knowledge overclocking anything, told when bought computer should enable xmp.
thanks,
adam
bump , here ram settings before , after enabling xmp:
code:xmp disabled: system memory multiplier (spd): auto frequency: 1333 1333 performance enhance: turbo dram timing selectable (spd): auto profile ddr voltage: 1.5 v profile qpi voltage: 1.1 v x channel interleaving: 6 auto x rank interleaving: 4 auto xmp enabled: system memory multiplier (spd): auto frequency: 1600 1600 performance enhance: turbo dram timing selectable (spd): auto profile ddr voltage: 1.65 v profile qpi voltage: 1.3 v x channel interleaving: 6 auto x rank interleaving: 4 auto channel timings: xmp disabled xmp enabled cas latency time: 9 8 trcd: 9 8 trp: 9 8 tras: 24 20 trc: 33 36 trrd: 4 5 twtr: 5 6 twr: 10 12 twtp: 21 24 twl: 7 8 trfc: 74 88 trtp: 5 6 tfaw: 20 24 command rate (cmd): 1 1 b2b cas delay: - - round trip latency: 46 46 channel b same round trip latency 48. system memory multipler options: 6.0, 8.0, 10.0 performance enhance options: standard, turbo, extreme
Forum The Ubuntu Forum Community Ubuntu Official Flavours Support Hardware [other] Can't boot after enabling XMP
Ubuntu
Comments
Post a Comment